Soap-based lithium and zinc oxide grease con-
taining NLGI 2; ISO-L-XBCIB2
Rear
Removing the rear wheel
- Remove the muffler supporting bracket.
- Remove the rear mudguard.
- Remove the tapered spacer.
- Remove the rear wheel.
Refitting the rear wheel
To fit, follow the removal steps but in the reverse
sequence, being careful to fit the spacers on the
wheel axle as shown in the photograph.
Locking torques (N*m)
Muffler arm clamping screws 27 ÷ 30 Rear
wheel axle nut 104 ÷ 126 Shock absorber-
crankcase attachment bracket 20 ÷ 25 Lower
shock absorber clamping screw 33 ÷ 41 Nm
Rear brake calliper fixing screws 25 ÷ 30 Nm
Swing-arm
X7 250ie Suspensions
SUSP - 21
To Next Page
Loading...
Need help?
General