Removal
- Remove the front and rear handlebar cover.
- Place a suitable container to collect the oil, dis-
connect the oil pipe from the calliper and operate
the brake lever until no more oil comes out.
- Disconnect the oil pipe from the pump.
- Unscrew the two clamps of the U-bolt and re-
move the pump.
Refitting
- Upon refitting, perform the operation but in reverse order.
- Tighten the hydraulic line to the prescribed torque and purge the system.
- When the operation is over, tighten the brake fluid bleed screw to the prescribed torque.
WARNING
THE BRAKE FLUID IS HYGROSCOPIC, THAT IS, IT ABSORBS MOISTURE FROM THE SUR-
ROUNDING AIR. IF THE LEVEL OF MOISTURE IN THE FLUID EXCEEDS A GIVEN VALUE,
BRAKING EFFICIENCY WILL BE REDUCED. THEREFORE, ALWAYS USE FLUID FROM SEALED
CONTAINERS. UNDER NORMAL DRIVING AND CLIMATIC CONDITIONS YOU SHOULD CHANGE
THIS LIQUID EVERY TWO YEARS. IF THE BRAKES ARE USED INTENSELY AND/OR IN HARSH
CONDITIONS, CHANGE THE FLUID MORE FREQUENTLY.
CAUTION
Braking system X7 250ie
BRAK SYS - 12
To Next Page
Loading...
Need help?
General