- Remove the transmission cover.
N.B.
WHEN YOU ARE REMOVING THE TRANSMIS-
SION COVER YOU MUST BE CAREFUL NOT
TO DROP THE CLUTCH BELL.
Air duct
- Remove the transmission compartment air intake
cover shown in the photograph.
- Remove the five screws on two different levels
as well as the small casing.
Removing the driven pulley shaft bearing
- Remove the clip from the inside of the cover.
- Remove the bearing from the crankcase by
means of:
Specific tooling
020376Y Adaptor handle
020375Y Adaptor 28 x 30 mm
020412Y 15 mm guide
X7 250ie Engine
ENG - 3
To Next Page
Loading...
Need help?
General