Connecting your equipment
03
36
En
Connecting an iPod
This receiver has a dedicated iPod terminal that will allow
you to control playback of audio content from your iPod
using the controls of this receiver.
• Switch the receiver into standby then use the
supplied iPod cable to connect your iPod to the iPod/
iPhone/USB terminal on the front panel of this receiver.
• Push down on the PUSH OPEN tab to access the
iPod/iPhone/USB terminal.
•It is also possible to connect using the cable included
with the iPod, but in this case it is not possible to view
pictures via the receiver.
•For the cable connection, refer to also the operating
instructions for iPod.
•For instructions on playing the iPod, see Playing an
iPod on page 44.
Connecting a USB device
It is possible to playback files using the USB interface on
the front of this receiver.
• Switch the receiver into standby then connect your
USB device to the
USB
terminal on the front panel of
this receiver.
•Push down on the PUSH OPEN tab to access the USB
terminal.
•For instructions on playing the USB device, see
Playing a USB device on page 46.
MENU
MASTER
VOLUME
MCACC SETUP MIC
USB
iPod
iPhone
VIDEO
CAMERA
HDMI 4
CONTROL ON
/
OFF
iPod
iPod cable
(supplied)
This receiver
MASTER
VOLUME
MCACC SETUP MIC
USB
iPod
iPhone
VIDEO
CAMERA
HDMI 4
CONTROL ON
/
OFF
USB mass
storage device
This receiver
VSX-LX52_DFLXJ.book 36 ページ ２００９年６月１日 月曜日 午前９時５９分
To Next Page
Loading...
Need help?
General
