Before you start
01
8
En
• iPod and USB Ready
This receiver has the terminals for connecting an iPod
unit and a USB mass storage device.
The iPod terminal is ready for handling digital audio, and
this receiver’s enhanced compatibility makes on-screen
control of your iPod an added possibility.
The USB terminal allows you to listen to two-channel
audio from a USB mass storage device connected to this
receiver.
Checking what’s in the box
Please check that you’ve received the following supplied
accessories:
•Setup microphone (cable: 5 m)
• Remote control unit
•AA size IEC R6 dry cell batteries (to confirm system
operation) x2
•AM loop antenna
•FM wire antenna
• iPod cable
•Power cord
Multi-voltage model: x2
Australia and New Zealand model: x1
•These operating instructions
Installing the receiver
• When installing this unit, make sur e to put it on a
level and stable surface.
Don’t install it on the following places:
– on a color TV (the screen may distort)
– near a cassette deck (or close to a device that gives off
a magnetic field). This may interfere with the sound.
– in direct sunlight
– in damp or wet areas
– in extremely hot or cold areas
– in places where there is vibration or other movement
– in places that are very dusty
– in places that have hot fumes or oils (such as a kitchen)
• Do not touch this receiver’s bottom panel while the
power is turned on. The bottom panel gets hot when
the power is on, and touching it could cause burns.
Loading the batteries
CAUTION
Incorrect use of batteries may result in such hazards as
leakage and bursting. Observe the following precautions:
• Never use new and old batteries together.
•Insert the plus and minus sides of the batteries
properly according to the marks in the battery case.
•Batteries with the same shape may have different
voltages. Do not use different batteries together.
• When disposing of used batteries, please comply
with governmental regulations or environmental
public instruction’s rules that apply in your country or
area.
• WARNING
Do not use or store batteries in direct su
nlight or
other excessively hot place, such
as inside a car or
near a heater. This can cause batteries to leak,
overheat, explode or catch fire. It can also reduce the
life or performance of batteries.
Operating range of remote control unit
The remote control may not work properly if:
•There are obstacles between the remote control and
the receiver’s remote sensor.
•Direct sunlight or fluorescent light is shining onto the
remote sensor.
•The receiver is located near a device that is emitting
infrared rays.
•The receiver is operated simultaneously with another
infrared remote contr ol unit.
VSX-LX52_DFLXJ.book 8 ページ ２００９年６月１日 月曜日 午前９時５９分
To Next Page
Loading...
Need help?
General
