Basic playback
05
50
En
Naming station presets
For easier identification, you can name your station
presets.
1 Choose the station preset you want to name.
See Listening to station presets below for how to do this.
2 Press
T.EDIT
(
TUNER EDIT
).
The display shows PRESET NAME, then a blinking cursor
at the first character position.
3 Input the name you want.
Choose from the following characters for a name up to
eight characters long.
ABCDEFGHIJKLMNOPQRSTUVWXYZ
abcdefghijklmnopqrstuvwxyz
0123456789
!”#$%&’()
∗+,–./:;<=>?@[ \ ]^_{|} ˜ [space]
Use / to select a character, / to set the position,
and ENTER to confirm your selection.
Tip
•To erase a station name, simply repeat steps 1 to 3
and input eight spaces instead of a name.
• Once you have named a station preset, you can press
DISP when listening to a station to switch the display
between name and frequency.
Listening to station presets
You will need to have some presets stored to do this. See
Saving station presets on page 49 if you haven’t done this
already.
1 Press
TUNER
to select the tuner.
2 Press
CLASS
to select the class in which the station
is stored.
Press repeatedly to cycle thr ough classes A to G.
3 Press
PRESET
/
to select the station preset you
want.
• You can also use the number buttons on the remote
control to recall the station preset.
VSX-LX52_DFLXJ.book 50 ページ ２００９年６月１日 月曜日 午前９時５９分
To Next Page
Loading...
Need help?
General
