Power-Pole CM2 HPU User Manual

14
WARRANTY
CENTER
C
E
R
T
I
F
I
E
D
SECTION 1.9 – Electronics & Controllers
C-Monster Top Side Controls
FUNCTION 1: Setting As A Single, Port, or Starboard Unit
STEP 1 Press and hold the PROGRAM button for six seconds until the LED flashes RED and two chimes are
heard followed by a SINGLE BEEP.
• To set as a SINGLE HPU: Press and hold both UP and DOWN buttons simultaneously.
• To set as STARBOARD side HPU: Press and release the UP button.
• To set as PORT side HPU: Press and release the DOWN button.
STEP 2 Once you have made all desired setting changes, press and release the PROGRAM button to save
your settings and exit program mode. You will hear a series of beeps and the LED will return to flashing
GREEN.
C-Monster 2.0
C-Monster 1.0
FUNCTION 2: Key-Fob Speed Adjustment
NOTE: Default settings are set to 70% of the highest speed level. Tone increases with level (1-10).
STEP 1 Press and hold the PROGRAM button for six seconds until the LED flashes RED and two chimes are
heard followed by TWO BEEPS.
STEP 2 Press the UP button to raise the speed setting and DOWN button to lower the speed setting.
STEP 3 Once you have made all desired setting changes, press and release the PROGRAM button to save
your settings and exit program made. You will hear a series of beeps and the LED will return to flashing
GREEN.
Press UP for
higher speed
setting / higher
sensitivity
Press DOWN for
lower speed /
lower sensitivity
Highest tone level
(FASTEST)
Middle range
tone level
(MEDIUM)
Lowest tone level
(SLOWEST)
10
1
C-Monster 2.0
C-Monster 1.0
Press both to set for Single Unit
Port (for duals)
Starboard
(for duals)
Program
Button
Press both to set for Single Unit
Port
Starboard
Program
Button
Program
Button
Default
Press UP for higher speed
setting / higher sensitivity
Press DOWN for
lower speed / lower sensitivity

Power-Pole CM2 HPU Specifications

General

Brand	Power-Pole
Model	CM2 HPU
Category	Water Pump
Language	English