16
WARRANTY
CENTER
C
E
R
T
I
F
I
E
D
SECTION 1.9 – Electronics & Controllers
C-Monster Controller Programming & Operation
Advanced Surface Mount Remote Control
PROGRAMMING:
STEP 1 Press and hold the PROGRAM button on the top of the HPU for three seconds. The LED will turn solid
GREEN. FIG 1 or 3
NOTE: If dual anchors are installed, perform STEP 1 for BOTH HPUs.
STEP 2 Press and release any button on the remote. The GREEN LED on the HPU will turn off, beep, and then
return to flashing once per second indicating the pairing has been completed. FIG 2 or 4
STEP 3 Test functionality by following the OPERATION Instructions.
IMPORTANT: C-Monster 2.0 controllers ARE NOT compatible with previous C-Monster pumps. The first time your
remote is paired to a recently-updated pump it may perform a firmware update. When this occurs the
remote will blink for approximately 1 minute. Please do not interrupt power to either the pump or
remote during this process. When the blinking has ceased your remote has finished updating and
is ready to use.
PROGRAM button
LED
Hydraulic Pump Unit (HPU)
Figure 3
C-Monster 2.0
Hydraulic Pump Unit (HPU)
Figure 1
Figure 2
C-Monster 1.0
LED
PROGRAM button
INSTALLATION:
NOTE: Make sure your Dash Switch is paired with all HPUs before installation.
Either:
Option 1: Mark and drill a pilot hole with 1/8” drill bit to fasten switch using the two supplied screws.
IMPORTANT! do not over tighten screws
OR
Option 2: Use supplied adhesive strip to mount Dash Switch.
C-Monster 1.0
C-Monster 2.0
Figure 4
To Next Page
Loading...
Need help?
General