18
WARRANTY
CENTER
C
E
R
T
I
F
I
E
D
C-Monster 1.0 C-Monster 2.0
Hydraulic Pump Unit (HPU)
Figure 1
LED
PROGRAM button
Hydraulic Pump Unit (HPU)
Figure 3
C-Monster 1.0 Key Fob
Figure 2
C-Monster 2.0 Key Fob
Figure 4
C-Monster 2.0
PROGRAM button
LED
SECTION 1.9 – Electronics & Controllers
PROGRAMMING:
STEP 1 Press and hold the PROGRAM button on the top of the HPU for
three seconds. The LED will turn solid GREEN. FIG 1 or 3
STEP 2 Press and release any button on the remote. The GREEN LED on
the HPU will turn off, beep, and then return to flashing once per
second indicating the pairing has been completed. FIG 2 or 4
NOTE: If dual anchors are installed, perform STEPS 1-2 for the other
HPU.
STEP 3 Test functionality by following the OPERATION Instructions.
IMPORTANT! The first time your CM2 remote is paired to a recently up-
dated pump it may perform a firmware update. When this
occurs the remote will blink for approximately 1 minute.
Please do not interrupt power to either the pump or remote
during this process. When the blinking has ceased your
remote has finished updating and is ready to use.
OPERATION:
To raise or lower the Power-Pole, press and hold either the UP or DOWN
button on the Key Fob. The anchor will only continue to move while the
button is depressed
Auto Mode
Double tapping (depressing and releasing 2 times within 1 second)
the UP or DOWN button will cause the anchor to retract or deploy
automatically. The Power-Pole will continue to move in said direction until
it retracts completely or senses the bottom.
IMPORTANT! C-Monster 2.0 controllers ARE NOT compatible with
previous C-Monster pumps
C-Monster Controller Programming & Operation
Remote Control Key Fob
C-Monster 1.0
To Next Page
Loading...
Need help?
General