14 | MOVE ZR Installation & Owner’s Guide
TRANSDUCER CABLE ROUTING
STEP 1 Route the Transducer Wire through the center of the Coil Cable.
STEP 2 Route the Transducer Wire along the side of the U-Channel. Leave an additional 3-4" loop.
IMPORTANT! If you do not leave enough slack in the transducer cable, it will break when stowing, deploying or fully
turning the unit.
STEP 3 Using a cable tie, attach the wire from the MFD to the first hole on the U-Channel. Repeat this process for
every other hole on the U-channel.
IMPORTANT! DO NOT attach the wire to the last two holes on ZR 45 Models or THREE HOLES on ZR 52
and 60 Models. This will negatively affect the locking mechanism on the ZR.
9-Pin Connector
3-4" loop
U-Channel Holes
Transducer Cable
DO NOT SECURE CABLE
TO THESE HOLES
Coil Cable
STEP 4 Attach the connector from the MFD to the Lowrance Tranducer Adapter Cable
36
and route to MFD.
IMPORTANT! Always attach the transducer wire to the to the side of the unit closest to the center line of the
boat so the wire is not crossing over the unit, otherwise the wire may be damaged when stowing
and deploying.
If you fail to route the Transducer Wire as shown, it will be damaged when operating the unit.
36
To Next Page
Loading...
Need help?
General