24 | MOVE ZR Installation & Owner’s Guide
24v WIRING
Wiring with Two 12v Batteries Connected in Series
STEP 1 Read ALL safety warnings and precautions on p. 23 before installing the Move.
STEP 2 Install a connector cable to the negative (-) post of Battery 1 (high side) and positive (+) post of Battery 2 (low side).
STEP 3 Connect the positive (+) lead from the Move to the positive (+) post of Battery 1 (high side).
Negative Lead from
Move
Connector Cable
Battery 1 High Side Battery 2 Low Side
STEP 4 Connect the negative (-) lead from the Move to the negative (-) post of Battery 2 (low side).
Wiring with a single 24v Lithium Battery
STEP 1 Read ALL safety warnings and precautions on p. 23 before installing the Move.
STEP 2 Connect the positive (+) lead from the Move to the positive (+) post.
NOTE: The Move may also be wired to multiple 24v batteries wired in parallel.
STEP 3 Connect the negative (-) lead from the Move to the negative (-) post.
Negative Lead from
Move
Before proceeding, allow battery compartment to vent for at least 15 minutes. This allows any combustible gases
that have built up in the compartment to escape.
Positive Lead from
Move
To 50 Amp Circuit
breaker
Positive Lead from
Move
To 50 Amp Circuit
breaker
The positive lead on a 24v setup MUST be wired through a 50 Amp Circuit Breaker.
The positive lead on a 24v setup MUST be wired through a 50 Amp Circuit Breaker.
To Next Page
Loading...
Need help?
General