MOVE ZR Installation & Owner’s Guide | 23
CONNECTING the MOVE
All MOVE models are designed to work with 24 and 36 volt systems and will automatically adjust for
your battery setup.
IMPORTANT CONNECTION INFORMATION
For safety and compliance reasons, we recommend that you follow American Boat and Yacht Council (ABYC)
standards when wiring your boat. These instructions are meant to serve as a general guide for connecting your
MOVE to power. If you have questions, contact our Customer Service Team at +1(813) 689-9932 option 2 or
visit our website at www.power-pole.com.
READ BEFORE INSTALLING
• The MOVE is compatible with all battery types. However, for best results use deep cycle marine batteries.
• To extend the life of your batteries and avoid premature battery failure, charge them within 12-24 hours of use.
• Use the Power-Pole CHARGE in conjunction with your trolling motor batteries for even longer-lasting performance.
• Ensure all battery terminals are clean and free from corrosion before installing.
Never connect the positive (+,POS) and negative (-,NEG) terminals of the same battery together.
Take care that no metal object falls onto the battery and shorts the terminals. It might spark or short-circuit
battery or other electrical component that may cause explosion.
For safety reasons, do not turn the trolling motor on until the propeller is in the water.
• For safety reasons, disconnect the trolling motor from the battery or batteries when the motor is not in use
or while the battery/batteries are being charged.
• Improperly connecting the trolling motor to a 24/36 volt system could cause battery explosion.
• Always make sure leadwire connections are tight and secure to battery terminals.
• Make sure batteries are in a well-ventilated compartment.
Please read the following information before connecting your trolling motor to your batteries to
avoid damaging the trolling motor and/or voiding the warranty.
These guidelines apply to the general rigging to support your Power-Pole MOVE trolling motor.
Powering multiple motors or additional electrical devices from the same power circuit may impact the
recommended conductor gauge and circuit breaker size. If your wire extension length is greater than 25 ft.,
we recommend you contact a Certified Warranty Center or Customer Service.
An over-current protection device (circuit breaker or fuse) must be used. Coast Guard requirements
dictate that each ungrounded current-carrying conductor must be protected by a manually reset, trip-free
circuit breaker or fuse. The type (voltage and current rating) of the fuse or circuit breaker must be sized
accordingly to the trolling motor used.
To Next Page
Loading...
Need help?
General