44 | MOVE ZR Installation & Owner’s Guide
ERROR CODE DESCRIPTION
A2 Navigation Head Circuit Board not checked-in
A3 Steering Circuit Board not checked-in
A4 Propulsion Circuit Board not checked-in
A5
Steering Motor not checked-in
C1 No Steering Calibration
C2 No Navigation Head Circuit Board Compass Calibration
C3 No Base Circuit Board Compass Calibration
C4 Poor Navigation Head Circuit Board Compass Calibration
C5
Poor Base Circuit Board Compass Calibration
C6 Shaft slip detected
C7 Poor Steering Calibration
E0 Battery below 16v on power up; operation not possible
E1 Battery less than 10v; unit will turn off
E2 Base PCB solid state relay failed to turn on
E3 Low voltage on power up (possible short)
E4 Battery less than 16v during operation
E5 Electrolysis Detected
F1 Steering no current
F2 Steering over-current
F3 Steering stall
F4 Steering over temp
G2 Navigation Head Circuit Board Ping Test failure; poor communication
G3 Steering Circuit Board Ping Test failure; poor communication
G4 Propulsion Circuit Board Ping Test failure; poor communication
H1 Propulsion Motor Circuit Board over temp
H2 Propulsion Motor max RPM below expectation
L2
Poor Navigation Head Circuit Board Communication
L3 Poor Steering Circuit Board Communication
L4 Poor Propulsion Circuit Board Communication
DISPLAY ERROR CODES
APPENDIX E Error Codes and Update LED Colors
To Next Page
Loading...
Need help?
General