MOVE ZR Installation & Owner’s Guide | 29
FEATURES OVERVIEW
MOVE ZR FEATURES TERMINOLOGY
ANCHOR MODE
Anchor Mode uses GPS to hold your boat in place, taking the current and wind into account. When Anchor Mode is on, the
Anchor Mode LEDs on the Info Display and Navigation Head will be solid yellow. Anchor Mode can be turned on/off
using the Move Remote or Anchor Mode Foot Button.
• Anchor Jog
When in Anchor Mode, the buttons on the Move Remote with an Orange Dot (•) can be used to "Jog" the Move.
Each time you tap one of these buttons, the Move will jog 5' in a corresponding direction.
NAVIGATION MODE
The Move has two navigation modes: Compass Heading and Vector Heading. Compass Heading is the default
navigation mode. The default Navigation Mode can be changed in the app. Steering the Move when Navigation Mode
is on will set a new heading. Navigation Mode can be set using the Move Remote. In Navigation Mode, the Navigation
Mode LEDs on the Info Display and Navigation Head will be solid teal.
• Compass Heading
In Compass Heading, the Navigation Head will always point in the exact direction it was set in. However, the wind and
current will affect the course of your vessel.
• Vector Heading
In Vector Heading, the Navigation Head will follow a set line from the exact direction it was set in. Unlike Compass
Heading, in Vector Heading your vessel will follow a straight line regardless of what the wind and current are doing.
ACTIVE HEADING
When the Active Heading Foot Button is double tapped, both the propeller (at current set speed) and Navigation Mode
turn on (a single tap will not turn on Active Heading).
NOTICE: This will either be Compass Heading or Vector Heading, depending on what is set in the app.
The Navigation Mode LEDs on the Info Display and Navigation Head will be solid teal. The Prop Icon LED on the
Info Display will be solid green and the Navigation Head LED will be solid green. If you steer in Active Heading, the Move
will stay in Active Heading mode, and the heading will be updated.
While in Active Heading mode: pressing the Momentary On button on the Foot Pedal, the Prop or Navigation Buttons on the
Move Remote, or the Navigation Heading Foot Button will turn off both the propeller and Navigation Mode, disengaging
Active Heading Mode.
REVERSE
The prop will spin in reverse. The prop speed will be displayed on the Info Display and can be adjusted via the Remote. The
Prop Icon LED on the Info Display will be solid orange and the Navigation Head LED will be solid orange. It is pre-
programmed to a set speed of 10. With Reverse engaged, the reverse speed can be changed using the and buttons
on the Move Remote. Once the unit has been taken out of Reverse mode, the most recent speed setting will be saved until the
Move is turned off, at which point the reverse speed will revert back to10.
NOTICE: Only use reverse in open water or areas with soft vegetation that will not damage the trailing edge of the propeller.
To Next Page
Loading...
Need help?
General