26 | MOVE ZR Installation & Owner’s Guide
TROLLING MOTOR TERMINOLOGY
Navigation Head
The Navigation Head has an internal compass
and 3 LEDs: (Anchor Mode , Navigation
Heading , and Prop ) which convey
Move status information. (Navigation Head
LED diagram p. 30)
Titanium Shaft
The Titanium Shaft was built to be as light
and tough as possible and features a
lifetime warranty.
Shaft Clamp
The Shaft Clamp is used to adjust the
depth of the propulsion motor for operation
or moving it into the ideal stowing position.
Security Strap
When the unit is in the stowed position, the
Security Strap wraps around the shaft to keep
the unit secure when transporting or running
on the water.
Propulsion Motor
Titanium Shaft
Shaft Clamp
Navigation Head
Lock Bar
Pull Cord
Pull Cord
The Pull Cord is used to safely stow and deploy the trolling motor. When the trolling motor is in a deployed position, lifting up
on the pull cord will disengage the lock bar and allow the unit to be safely stowed.
Lock Bars
The Lock Bars keep the unit held in its stowed and deployed positions. They are located on the lower arm and lock into place
when the unit is in a deployed position. These also provide a secondary method to stow and deploy the unit if the Pull Cord
breaks.
Propulsion Motor
The Propulsion Motor is responsible for driving the Move. It features an ultra-quiet, efficient brushless motor.
Security Strap
When stowing or deploying the motor, keep fingers clear of
all hinges, pivot points and moving parts. To prevent injury,
always use the Pull Cord to stow or deploy the unit.
OPERATING the MOVE
Here’s all the information you’ll need on the functions, safe use, and maintenance of the MOVE. If you have
questions, contact our Customer Service Team at +1 (813) 689-9932 option 2 or visit our website at
www.power-pole.com.
Lock Bar
To Next Page
Loading...
Need help?
General