MOVE ZR Installation & Owner’s Guide | 39
FAQ ’S
Q: Why is Anchor Mode/Navigation Mode behaving erratically?
A: The GPS signal may be obstructed. Ensure there are no large pieces of metal near the head and no magnets within the vicinity.
If there are magnets within a few feet of the Navigation Head, it will interfere with the GPS signal. If there is nothing obstructing the
signal, you may need to recalibrate your Navigation Head Circuit Board. This can be done in the Power-Pole App.
Q: Why is Anchor Mode too aggressive/not aggressive enough?
A: Anchor Mode is configurable in the Power-Pole App. Also, for best operation, make sure the Propulsion Motor is at least 12" below
the water's surface.
Q: I don't have Power-Pole Shallow Water Anchors, why are there buttons on the remote?
A: Most avid anglers find that having a combination of a GPS trolling motor and shallow water anchors allow for optimum boat
control while chasing fish in a variety of conditions. The team of anglers at Power-Pole wanted one remote to control all of the
Power-Pole accessories on their boat, so the anchor buttons were integrated into the remote.
Q: Why is my display showing a random number?
A: The Move is most likely either updating or the display is relaying an error code.
Q: Will the Move drain my batteries when not in use?
A: As with any device, it is recommended to either turn off the main power cutoff switch or disconnect from power when not in use.
The Move's accessories do have a slight power draw. For more information see Appendix D (p. 43).
To Next Page
Loading...
Need help?
General