dosemeter User Manual
Page 66
Appendix 4 Resetting the dosemeter and Reader Unit
Resetting the dosemeter
If, in the event that the dosemeter does not respond correctly to commands
from the Reader Unit and if all of the troubleshooting steps have been
followed, this reset procedure can be followed.
This procedure should only be followed if the MODEL 22 dosemeter does not respond to
commands from the MODEL 22R Reader Unit. Please ensure that all of the
troubleshooting listed above has been followed before carrying out this procedure.
In particular, ensure that the section covering the Shake-to-Wake function has
been read and understood.
Please contact Pulsar Instruments plc or your local distributor for further details.
The purpose of this procedure is to perform a hard reset on a MODEL 22 (dosemeter).
This procedure should only be followed, if you have been instructed to do so by Pulsar
Instruments, on an individual unit.
The actions described in this procedure should not erase any data from your dosemeter
unit, but Pulsar Instruments plc do not take any responsibility for loss of data or any
damage that occurs to your dosemeter from following this procedure.
Please fully read and make sure you understand the whole procedure before starting it.
If you do not feel confident about following the procedure, please do not attempt it!
Warnings
This symbol is used throughout this procedure to indicate that special
attention should be taken and any instructions followed carefully.
1. With a small, high quality Philips PH00 screwdriver remove the three screws
from the base of the dosemeter.
SCREWS
To Next Page
Loading...
Need help?
General
