+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
4. mac-notification trap configuration
mac-address-table synchronizing
enable
no mac-address-table
synchronizing enable
Enable the monitor function for MAC, if a MAC is
added or deleted, the system will report this monitored
event; the no command will cancel this function.
mac-address-table periodic-
monitor-time <5-86400>
Set the MAC monitor interval to count the added and
deleted MAC in time, and send out them with trap
message.
mac-address-table trap enable
no mac-address-table trap enable
Enable or disable mac notification trap passthrough.
17.5.1.3 Binding MAC Address Binding Troubleshooting
Enabling MAC address binding for ports may fail in some occasions. Here are some possible
causes and solutions:
If MAC address binding cannot be enabled for a port, make sure the port is not enabling port
aggregation and is not configured as a Trunk port. MAC address binding is exclusive to such
configurations. If MAC address binding is to be enabled, the functions mentioned above must
be disabled first.
If a secure address is set as static address and deleted, that secure address will be unusable
even though it exists. For this reason, it is recommended to avoid static address for ports
enabling MAC address.
17.6 MAC Notification
Configuration
17.6.1 Introduction to MAC Notification
MAC Notification function depends on the notification. Add or remove the MAC address,
namely, when the device is added or removed, it will notify administrator about the changing by
the trap function of snmp.
17.6.2 MAC Notification Configuration
Mac notification configuration task list:
To Next Page
Loading...
Need help?
General
