Quantum DXi V-Series User Manual

Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-09 Rev B
February 2014
Replication CLI Commands 51
cartridges, you will only be able to select DLT-S4 tape drives when mapping
devices to the recovered partition.
Recovering a NAS Share
on the Target
syscli --recover nas --repname <replicated_NAS_share_name> --srchost
<source_hostname_or_IP_address> --id <ID_of_the_replicated_NAS>
[--recname <recovered_NAS_share_name>] [--owner <owner_user_id>]
[--submit]
This CLI command allows the admin user to recover and recreate the NAS share
on the target system. The replicated NAS share name, source hostname and ID
can be retrieved from the list of replicated NAS share. If the --recname option is
specified, it is used as the NAS share name when the share is successfully
recovered. Otherwise, the same replicated NAS share name will be used for the
recovered share name on the target. The --owner option is mandatory if the
share being recovered is a CIFS share. If the --submit option is specified, it does
not wait for the recover operation to complete.
Failback VTL To the
Source from the Target
System
syscli --failback repvtl --repname <vtl_name> --srchost <source_host> --id
<id> --tgthost <target_host> [--encrypt [--encrypttype 128|256]]
This CLI command allows the CLI admin to failback a replicated VTL. The
replicated VTL name, source hostname and ID can be retrieved from the list of
replicated VTL. The --tgthost option specifies the target host where the
replicated VTL will be failed back to.
To complete the failback, on the specified target system, run the --recover vtl
CLI command specifying the replicated VTL from the list of replicated VTL on the
failback target host system.
Before a user can failback a VTL to its source, the target role IP address must be
configured on the source system first.
If the --encrypt option is specified, it encrypts the failback to the failback target.
CLI command options:
• --failback: Failback replicated VTL on to a target host.
•--repname: Replicated VTL name to failback.
• --srchost: Source host of the original VTL. Use --list repvtl as reference
• --id: ID from list of replicated VTL. For multiple replication of the VTL name,
ID identifies the replicated batch.
• --tgthost: Target host to failback to. The target host must have this system
as as one of the allowed replication source. Use IP address if the hostname
cannot be resolved from the system.
• --encrypt: Encrypt the failback to the source.
• --encrypttype: if specified, the encryption type will be either 128 bits or 256
bits encryption.

Quantum DXi V-Series Specifications

General

Brand	Quantum
Model	DXi V-Series
Category	Storage
Language	English