Quantum DXi V-Series User Manual

Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-09 Rev B
February 2014
90 Utility CLI Commands
ReclaimableSpace=0.00MB
More information regarding space reclamation can be found in two reports that
are produce by Quantum's DXi Advanced Reporting (DAR) application.
•The Space Reclamation Report presents space reclamation progress and
space reclamation in bytes.
•The Disk Usage graph in the Capacity Report presents reclaimable space,
which is the amount of disk space available for new deduplicated data.
Node Management syscli --nodemanage --reboot | --shutdown | --resetdiag [--node {1 | 2|
all}] [--sure]
This CLI command allows the admin user to reboot, shutdown or reset the
diagnostic state on a node. If the --sure option is specified, no confirmation
prompt is displayed. Note that --node 2 is an invalid option in release 2.x.
License Management The following license management commands are available:
• Displaying Licenses
• Adding a License
• Getting License Status (DXi V-Series only)
• Activate a License (DXi V-Series only)
Displaying Licenses
syscli --list license
This CLI command allows the user to list the available licenses on the system. An
example output of available licenses is shown below:
ListofLicenses:
Totalcount=7
[License=1]
LicenseName=NAS
Installed=No
DateInstalled=‐‐NotInstalled‐‐
LicenseDescription=ExposeNASinterfacetohost
[License=2]
LicenseName=BackupApplicationSpecific
Installed=No
DateInstalled=‐‐NotInstalled‐‐
LicenseDescription=EnablesBackupApplicationSpecific
[License=3]

Quantum DXi V-Series Specifications

General

Brand	Quantum
Model	DXi V-Series
Category	Storage
Language	English