Quantum QX Series User Manual

Chapter 5: Troubleshooting
Isolate Replication Faults
QX and QXS Setup Guide 148
Answer Possiblereasons Actions
No Network error
occurred during in-
progress
replication.
l Review event logs for indicators of a specific fault in a replication data path
component. Follow any Recommended Actions.
l Click in the Volumes topic, then click on a volume name in the volumes
list. Click the ReplicationSets tab to display replications and associated
metadata.
l Replications that enter the suspended state can be resumed manually.
No Communication
link is down.
See actions described in Can you view information about remote links?
Has a replication run successfully?
Answer Possiblereasons Actions
Yes System
functioning
properly.
No action required.
No Last Successful
Run shows N/A.
l In the Volumes topic, click on the volume that is a member of the
replication set.
Select the Replication Sets table.
Check the Last Successful Run information.
l If a replication has not run successfully, use the disk management utility to
replicate as described in the “Working in the Replications topic” in the V3
disk management utility.
No Communication
link is down.
See actions described in Can you view information about remote links?
Table28:Replication Run Successfully
Virtual Replication Using the V2 Disk Management Utility
Can you successfully use the replication feature?

Quantum QX Series Specifications

General

Brand	Quantum
Model	QX Series
Category	Storage
Language	English