Quantum QX Series User Manual

Chapter 5: Troubleshooting
Isolate Replication Faults
QX and QXS Setup Guide 149
Answer Possiblereasons Actions
Yes System
functioning
properly.
No action required.
No The replication
feature is not
licensed on each
RAID chassis
used for
replication.
Verify licensing of the optional feature per system:
l In the Configuration View panel in V2 disk management utility, right-click
on the system, and select View>Overview. Within the System Overview
table, select the LicensedFeatures component to display the status of
licensed features.
l If the Replication feature is not enabled, obtain and install a valid license
for this feature.
l Linear replication is only supported by QXS-3, -4 and -6 Series iSCSI RAID
chassis.
No Compatible
firmware revision
supporting the
replication feature
is not running on
each system used
for replication.
Perform the following actions on each system used for virtual replication:
l In the Configuration View panel in V2 disk management utility, right-click
the system, and select Tools>UpdateFirmware.
The Update Controller Modules tab shows firmware versions installed in
each controller.
l If necessary, update the controller module firmware to ensure compatibility
with the other systems.
No Invalid cabling
connection. (If
multiple RAID
chassis are used,
check the cabling
for each system.)
Verify RAID chassis cabling:
l Verify use of proper cables.
l Verify proper cabling paths for host connections.
l Verify cabling paths between replication ports and switches are visible to
one another.
l Verify that cable connections are securely fastened.
l Inspect cables for damage and replace if necessary.
Table29:Virtual Replication Using the V2
Can you view information about remote links?

Quantum QX Series Specifications

General

Brand	Quantum
Model	QX Series
Category	Storage
Language	English