Quantum QX Series User Manual

Chapter 2: Installing the Chassis
Populate QXS 48-Drive Drawers
QX and QXS Setup Guide 59
l If you are installing into the right drawer, refer to the illustration on the right when performing this step-
procedure.
Figure65:Installing an AMS into a Drawer
1. Squeeze the latch release flanges together—so that the locking-nib will clear the sheet metal bay
wall—and insert the AMS into the target drive slot.
2. Verify that the AMS insert is firmly seated in place.
Install the remaining AMS inserts into the applicable empty drive slots.
The installed AMS inserts should now appear as shown in Figure 66 below
Figure66:Securing AMS into a Drawer
1
4
3
2
5
6
1. Drawer0
2. 2.5"sleddeddrives0-3
1,2
3. DrivestatusLED
4. 2.5"sleddeddrives4-7
1,2

5. 2.5"sleddeddrives8-11
1,2
6. AMSinsert(slots12-15)
3
1
The drive is oriented in the sled such that its PCBA faces upward on the top side of the drive module as shown.
2
Electromagnetic interference protection is provided by the EMI shield within the chassis bezel.
3
The AMS insert spans only one drive slot. Slots 12-15 have AMS inserts (4 each) installed.

Quantum QX Series Specifications

General

Brand	Quantum
Model	QX Series
Category	Storage
Language	English