LTE Standard Module Series
EC200T Series Hardware Design
EC200T_Series_Hardware_Design 9 / 90
1 Introduction
This document defines the EC200T series module and describes its air interface and hardware interfaces
which are connected with your applications.
This document can help you quickly understand module interface specifications, electrical and
mechanical details, as well as other related information of EC200T series module. Associated with
application note and user guide, you can use EC200T series module to design and set up wireless
applications easily.
According to the definition of mobile and fixed device is described in Part 2.1091(b), this device is a
mobile device.
And the following conditions must be met:
1. This Modular Approval is limited to OEM installation for mobile and fixed applications only. The antenna
installation and operating configurations of this transmitter, including any applicable source-based time-
averaging duty factor, antenna gain and cable loss must satisfy MPE categorical Exclusion Requirements
of 2.1091.
2. The EUT is a mobile device; maintain at least a 20 cm separation between the EUT and the user’s body
and must not transmit simultaneously with any other antenna or transmitter.
3.A label with the following statements must be attached to the host end product: This device contains
FCC ID: XMR202011EC200TAU.
4.To comply with FCC regulations limiting both maximum RF output power and human exposure to RF
radiation, maximum antenna gain (including cable loss) must not exceed:
❒ GSM850 :≤8.571dBi
❒GSM1900 :≤10.03dBi
❒ LTE Band2/25:≤11.000dBi
To Next Page
Loading...
Need help?
General
