R&S FPC Series User Manual

Remote Control
R&S
®
FPC
302User Manual 1178.4130.02 ─ 07
Return values:
<Result> When you query the fixed frequency measurement result, the
command returns one value: the level for the current receiver
frequency.
When you query frequency scan results, the command returns
several level values. The number of return values depends on
the number of measurement frequencies.
Example: //Query measurement results
TRAC?
//Query maxhold information
TRAC? PHOL
Usage: Query only
19.13.7
Marker
Note that markers are only available for the frequency scan.
Commands to configure markers described elsewhere.
●
Marker state (on / off):
CALCulate<n>:MARKer<m>[:STATe]
CALCulate<n>:MARKer<m>:AOFF
●
Marker input mode:
CALCulate<n>:MARKer<m>:FREQuency:MODE
●
Marker position:
CALCulate<n>:MARKer<m>:X
CALCulate<n>:MARKer<m>:Y?
●
Marker position: set to peak:
CALCulate<n>:MARKer<m>:MAXimum[:PEAK]
●
Marker position: set to next peak:
CALCulate<n>:MARKer<m>:MAXimum:NEXT
●
Marker position: set to minimum:
CALCulate<n>:MARKer<m>:MINimum[:PEAK]
●
Marker search range:
CALCulate<n>:MARKer<m>:X:SLIMits<slim>:LEFT
CALCulate<n>:MARKer<m>:X:SLIMits<slim>:RIGHt
CALCulate<n>:MARKer<m>:X:SLIMits<slim>[:STATe]
Commands to configure delta markers described elsewhere.
●
Delta marker state (on / off):
CALCulate<n>:DELTamarker<m>[:STATe]
CALCulate<n>:DELTamarker<m>:AOFF
●
Delta marker position:
CALCulate<n>:DELTamarker<m>:X
●
CALCulate<n>:DELTamarker<m>:X:RELative
Remote Commands of the Receiver Application

R&S FPC Series Specifications

General

Brand	R&S
Model	FPC Series
Category	Measuring Instruments
Language	English