CHAPTER 11
96 Raven RS1™ and RS Lite™ Calibration and Operation Manual
• 128 - Data cannot be parsed.
• Any other value indicates signal from the radio. Values closer to zero (0) indicate better signal strength.
Packet Drop. Count of instances when transmission was limited due to poor connection on the RF channel.
VSWR (Voltage Standing Wave Ratio). A voltage ratio measured from the last packet sent from the radio.
• ≥ 100 indicates a poor radio connection.
• 99 to 11 indicates a moderate radio connection.
• ≤ 10 indicates a good radio connection.
Tx (Transmit) Success. Percent of packets which were transmitted successfully.
Signal Level. Displays the decibel-milliwatts (dBm) of the last packet received via the radio.
NOTE: A value of 128 indicates that no packet has been received since statistics were cleared.
Rx (Receive) Success. Percent of packets successfully received.
Signal Margin. A value between 0 (zero) and 100 which indicates the difference between signal level and either
the receive sensitivity or the noise level, whichever is higher. Higher values indicate a better margin.
Ping Time. Time, in milliseconds, to test the connection between the RS Lite and the local radio.
Radio Frequency. The radio operating frequency in MHz (mega-hertz).
Latency. Time, in seconds, required to send a command and receive a response from the local radio.
Uptime Seconds. The number of seconds since the radio restarted minus the uptime days field.
Uptime Days. The number of days since the radio restarted.
To Next Page
Loading...
Need help?
General
