CHAPTER
7
016-4010-001 Rev. J 43
CHAPTER 7
GPS CONFIGURATION
CONFIGURE RS1 VIA THE VIPER 4
To configure the RS1 GNSS receiver via the VIper 4:
1. From the ROS main page, select the Edit button.
2. Select the GPS menu.
FIGURE 1. GPS Setup
3. Select the NMEA2000 option.
NOTE: NMEA2000 is the default option for the ROS device. If the RS1 is replacing a steering system, ensure
that the old steering ECU is disconnected from the ISOBUS. Perform a serial redetect before
proceeding.
If multiple devices are configured to output NMEA messages over the ISOBUS, be sure to select the
correct device to ensure proper operation of the RS1.
FIGURE 2. GPS Setup Page
To Next Page
Loading...
Need help?
General
