CHAPTER
9
016-4010-001 Rev. J 51
CHAPTER 9
ROUTINE OPERATION
WIDGET DEFINITIONS
The following are common status or mode information which may be displayed in the RS1 system while in a job:
NOTE: Refer to Diagnostic Trouble Codes (DTC) section on page 58 for additional status conditions which
may be displayed in the RS1 or RS Lite on-screen widget.
UT NAVIGATION BUTTONS
ROS CRX Message
The RS1 is detected, but the operator must accept
responsibility for the operation of the RS1 system.
No A-B path or guidance line has been set or an
active DTC is preventing the RS1 system from
engaging.
RS1 is detected, turned on, and calibrated.
RS1 is detected and in operation.
Vehicle speed is too fast or too slow for RS1
operation and the system will disengage.
Accept - Saves the changes made to the system at the end of the setup process
and returns the to the Tools Menu.
Next - Saves the changes made to the system and proceeds to the next step in
the setup process.
Previous - Returns to the previous page in the setup process.
To Next Page
Loading...
Need help?
General
