CHAPTER 7
46 Raven RS1™ and RS Lite™ Calibration and Operation Manual
SERIAL OUTPUT CONFIGURATION
FIGURE 6. Serial Output Configuration Page
Config Types. Allows the RS1 system to toggle between a serial 3D compensated GNSS position output or a
simulated radar output.
NOTE: The baud rate and message types are not used in radar outputs.
GPS OUT
Baud Rate. The rate for messages transmitted over the serial port. This rate must be set to match the devices on
the system which are intended to receive messages from the RS1 or RS Lite.
NOTE: The default baud rate setting is 115200 and is recommended for all steering systems.
Message Types. Set the frequency for each required NMEA message.
NOTE: Changing message types and rates may cause poor system performance. It is not recommended to
change message rates unless instructed by documentation or Raven technical service.
DIFFERENTIAL CONFIGURATION SETUP
FIGURE 7. Differential Configuration Page
To Next Page
Loading...
Need help?
General
