CHAPTER 5
28 Raven RS1™ and RS Lite™ Calibration and Operation Manual
FIGURE 3. Machine Offsets Setup Page
• Antenna Height - The Antenna Height is calculated by measuring from the ground to the center of the RS1
unit.
• Antenna Center Offset - The Antenna Center Offset position is calculated by measuring from the center of the
machine to the center of the RS1 unit. Enter a negative value if the RS1 unit is located to the left of the machine
center line.
• Antenna Fore/Aft - The Antenna Fore/Aft position is calculated by measuring from the rear axle of the
machine to the middle of the RS1 unit. Enter a negative value if the RS1 unit is located behind the rear axle.
• Wheel Base - The Wheel Base is calculated by measuring from the center of the front tire to the center of the
rear tire.
NOTE: The Wheel Base is calculated by measuring from the center of the front tire to the center of the rear
tire on both sides of the machine. Add these measurements together and then divide by two to get
the average Wheel Base value.
• Help Menu Icon - Pressing the Help Menu icon displays the Help Menu. The Help Menu contains
additional information about the settings contained within that page.
To Next Page
Loading...
Need help?
General
