24
CLEARING THE REMOTE CONTROL SETTINGS
Clears all presets and restores factory default settings.
Press REMOTE SET UP and 0 at the same time for more 3 seconds.
The LED display at the top of the remote control will blink. After
blinking three times, all the settings will be canceled.
DIRECT FUNCTION
The direct function is a useful feature which allows you keep the receiver in one function (for example,
CD) while putting the remote control in a different function. This could let you, for example, use the
remote control to set up and listen to a CD on the receiver and then use the remote control to rewind a
tape in your VCR while you continue to listen to your CD player.
When the DIRECT function is ON any MULTI CONTROL button you press will change the function of
both the receiver and the remote control. When you turn the DIRECT function OFF, you can operate the
remote control without effecting the receiver. Thus you could switch the remote control the VCR and
operate that component while the receiver plays a different component.
1 To turn the DIRECT funtion OFF (the default setting is ON),
press REMOTE SET UP and number button 3 at the same time.
2 To turn the the DIRECT function ON (if you have turned it off),
press REMOTE SET UP and number button 2 at the same time.
To Next Page
Loading...
Need help?
General
