42
CABLE TV/SATELLITE TV/TV CONTROLS
This remote control can control these components after entering the proper codes (see p.22-
23).
Use MULTI CONTROL buttons to put the remote control in the stated mode.
THE FIRST FOUR BUTTONS ARE DEDICATED TV
CONTROL BUTTONS FOR ANY TYPE OF TV SETUP.
1 STANDBY/ON (power)
Press to switch the TV or CATV between STANDBY and ON.
2 TV FUNC. (TV only)
Press to switch the TV input (not possible with some models).
3 CHANNEL +/–
Use to select channels.
4 TV VOL +/– (TV only)
Use to adjust the TV volume.
5 4
Use to move to lower numbered channels
6 ¢
Use to move to higher numbered channels
7 5˜∞˜2˜3˜ENTER
Press to select or navigate and adjust items on the menu screen.
8 NUMBER buttons
Use to select channels directly.
9 +10 button
Use to select channels higher than 10.
0 EFFECT +/–
For TV and cable TV use this button to immediately enter a new
channel (CHANNEL ENTER function). For satellite TV use this button
to exit the menu screen.
- MENU
Use to select the menu screen.
= TOP MENU
Use to bring up the GUIDE on a satellite TV.
MULTI CONTROL
DVD/LD TV/SAT VCR/DVR CD
SOURCE CLASS MPX BAND
LOUDNESS FUNCTION MUTING
RECEIVER
D.ACCESS CHANNEL
ATT
VOL
MENU
TOP
MENU
VOL
CH
2
DSP MODE
MIDNIGHT
5.1CH
CD-R/
TAPE/MD
CHANNEL
SELECT
CHANNEL
LEVEL
EFFECT
ENTER
ENTER
FQ
FQ
ST ST
FL
DIMMER
REMOTE
SETUP
MASTER
VOLUME
TV CONTROL
FUNC
10 DISC
SIGNAL
SELECT
TEST
TONE
RECEIVER
TUNER
TV CONT
1234
1 ¡ 4 ¢
7 8 3
5678
90
‡
POWER
POWER
PREPROGRAMMED
AUDIO/VIDEO SYSTEM REMOTE
OSR
POWER
-
2
9
1
4
=
8
6
5
7
3
0
memo
To Next Page
Loading...
Need help?
General
