40
DVD/DVR PLAYER CONTROLS
This remote control can control these components after entering the proper codes (see p.22-
23).
Use MULTI CONTROL buttons to put the remote control in the stated mode.
1 SOURCE
Press to switch the DVD/DVR player between STANDBY and ON.
2 4
Press to return to the start of the current chapter (track). Repeated
presses skips to the start of previous tracks. When controlling a DVR,
use this button to go back channels (channel –).
3 ¢
Press to advance to the start of the next chapter (track). Repeated
presses skips to the start of following tracks. When controlling a DVR,
use this button to go forward channels (channel +).
4 8
Press to pause playback (on some models this will freeze-frame the
picture).
5 Number buttons
Use the number buttons to navigate the on-screen display.
The ENTER button is used as a SETUP button for the DVD players
internal menus. The
¶¶
¶¶
¶ button is used to selet tracks higher than 10
(+10 button).
6 TOP MENU
Use to display the lead trailer on a DVD.
7 ¡
Hold down for fast forward playback.
8 1
Hold down for fast reverse playback.
9 3
Press to start playback (on some models, pressing this when the disc
tray is empty will cause the disc tray to open).
0 7
Press to stop playback (on some models, pressing this when the disc is
already stopped will cause the disc tray to open).
- MENU
Displays menus concerning the current DVD or DVR you are using.
= USE THESE BUTTONS TO NAVIGATE DVD MENUS
5 : up
∞ : down
ENTER : enter the command selected
2 : left
3 : right
5∞ : pressed together starts recording
MULTI CONTROL
DVD/LD TV/SAT VCR/DVR CD
LOUDNESS FUNCTION MUTING
RECEIVER
D.ACCESS CHANNEL
ATT
VOL
MENU
TOP
MENU
VOL
CH
2
DSP MODE
MIDNIGHT
5.1CH
CD-R/
TAPE/MD
CHANNEL
SELECT
CHANNEL
LEVEL
EFFECT
ENTER
ENTER
FQ
FQ
ST ST
FL
DIMMER
REMOTE
SETUP
MASTER
VOLUME
TV CONTROL
FUNC
10 DISC
SIGNAL
SELECT
TEST
TONE
RECEIVER
TUNER
TV CONT
1234
1 ¡ 4 ¢
7 8 3
5678
90
‡
SOURCE CLASS MPX BAND
POWER
POWER
PREPROGRAMMED
AUDIO/VIDEO SYSTEM REMOTE
OSR
POWER
-
0
7
1
8
4
6
9
5
3
2
=
memo