Re T-one ULS - Programming Functions Summary

T-one ULS
Rev. 06/18 8/26
Programming
The following is a summary of the device programming functions available. For a more detailed description,
consult § Detailed description of programming functions on page 17.
Function Display Function description Value range
Factory
setting
STOP F.1 Braking in STOP 0÷100.0 10.0
F.2 STOP braking variation percentage 0÷100.0 50
F.3 Password check 0÷1000 0
F.4 Accessing the calibration * *
PRIORITY STOP F.8 Machine tension in PRIORITY STOP 0÷100.0 60.0
AUTO F.10 Taper percentage ± 100 0
F.11 Taper start diameter 0÷Max. diam. 800
F.12 Taper end diameter 0÷Min. diam. 300
F.13 Minimum braking in AUTO 0÷100.0 0.0
ACCELERATION F.15 ACC time 0÷120 0
F.16 Inertia contribution in ACC ± 100 0
DECELERATION F.17 DEC time 0÷120 0
F.18 Inertia contribution in DEC ± 100 0
ALARMS F.25 Activation mode for alarms 0÷2 0
F.26 First alarm threshold 0÷Min. diam. Min. diam.
F.27 Second alarm threshold 0÷Max. diam. Max. diam.
F.28 Alarms displaying 0÷1 0
CALIBRATION F.30 Setting the diameter input 0÷1 1
F.31 Decimal point 0÷2 0
F.32 Maximum diameter 0 1000
F.33 Calibrating the maximum diameter value * *
F.34 Minimum diameter 0 100
F.35 Calibrating the minimum diameter value * *
F.36 Enabling the remote set point 0÷1 0
F.37 Setting the minimum value of remote set point * *
F.38 Setting the maximum value of remote set point * *
F.39 Remote control 0÷1 1
SELEMATIC F.50 Braking section 1 percentage (SECT.1) 0÷400 200
F.51 Braking section 2 percentage (SECT.2) 0÷400 0
F.52 Braking section 3 percentage (SECT.3) 0÷400 0
GENERAL
SETTINGS
F.70 Type of adjusted output 0÷1 0
F.73 Display filter 0÷100 80
F.74 Analog inputs filter 0÷100 80
F.75 Setting the password 0÷1000 0
F.76 Functions reset * *
F.77 Display brightness 1÷10 10
F.78 Firmware version * *