REPLIGEN Spectrum KR2i User Manual

63 400-12355-000 Rev. 03
KR2i / KMPi TFF Systems
Auxiliary Component Setup and Operation
Single-use Conductivity/Temperature Flowpath Components
Combination Conductivity and Temperature in-line flowpath sensors; made of Polysulfone and in
assorted hosebarb sizes.
Optional: UV Photometer
Available in either 260 nm or 280 nm models; consists of 2 fiber optic cables, 2 optical couplers to
connect to flow cell, and power supply.
NOTE: UV Photometer cannot be remotely tared; to tare UV Photometer, press “TARE” button on
Photometer body.
Optional: Single-use UV Flowpath Components
UV in-line flowpath sensors; made of Polysulfone and in assorted hosebarb sizes.
10.4.2 Installation
Basic Setup
NOTE: Prior to assembling KONDUiT, ensure that TFF System has been properly set-up (see
Section 7 of KR2i / KMPi TFF Systems Product Information and Operating Instructions for TFF
System setup details).
1. With TFF System powered on, connect KONDUiT Communication Cable to “Auxiliary”
Octopus Cable (on KR2i) OR to a null modem cable that is then connected to “Valve 2”
Octopus Cable (on KMPi)
2. Connect KONDUiT Power Cable to KONDUiT Power Port
Figure 1: Back of KONDUiT, green power light on the On/Off button
indicates if KONDUiT is receiving power.
Figure 2: Front of KF KONDUiT

REPLIGEN Spectrum KR2i Specifications

General

Brand	REPLIGEN
Model	Spectrum KR2i
Category	Laboratory Equipment
Language	English