• Direct and easy scale-up for production volumes
Safety Precautions
DANGER: High voltages exist and are accessible. Use extreme caution when servicing
internal components.
Remove power from the pump before any cleaning operation is started.
WARNING Remove power from the pump before attempting any maintenance.
WARNINGS: Tubing breakage may result in fluid being sprayed from pump. Use
appropriate measures to protect operator and equipment.
Turn drive off before removing or installing tubes. Fingers or loose clothing
could get caught in drive mechanism.
CAUTIONS: Power must be turned off before connecting the external remote control
cable to prevent damage to the drive.
Do not contaminate the lubricant in the container, on the shaft or on the
seal with foreign material. Failure to observe this precaution may result in
damage to the seal and premature failure of the seal.
No foreign matter should be allowed under the gasket on the back of the
front plate or under the heads of the screws. Failure to observe this
precaution may result in leakage during washdown of the drive.
CAUTION: To avoid electrical shock, the power cord protective grounding conductor
must be connected to ground. Not for operation in wet locations as
defined by EN61010-1.
CAUTION: Keep fingers away from rotor while pump is in operation. Stop pump
before loading or unloading tubing.
Explanation of Symbols:
CAUTION: Risk of Danger. Consult Operating Instructions for nature of hazard and
corrective actions.
CAUTION: Risk of crushing. Keep fingers away from rotor while pump is in operation.
Stop pump before loading or unloading tubing.
CAUTION: Hot surface. Do not touch.
CAUTION: Risk of electric shock. Consult Operating Instructions for nature of hazard
and corrective actions.
To Next Page
Loading...
Need help?
General
