When You Cannot Make Copies as Wanted
25
2
❖ Duplex
When Memory is Full
This section explains likely causes of and possible solutions for problems related
to full memory.
Problem Cause Solution
Cannot print in duplex
mode.
You have loaded paper on the by-
pass tray.
Remove paper loaded on the by-
pass tray. Load paper in another
tray.
Cannot print in duplex
mode.
You have loaded paper exceed-
ing 90 g/m
2
.
Change the paper.
Cannot print in duplex
mode.
You have selected a tray which is
set to [1 Sided Copy] in [Tray Paper
Settings] in [System Settings].
Set the tray to [2 Sided Copy] in
[Tray Paper Settings] in [System Set-
tings]. See “System Settings”,
General Settings Guide.
Copies are not in cor-
rect order.
You placed the originals in the in-
correct order.
When placing a stack of originals
in the ADF, the last page should
be on the bottom.
If you place an original on the ex-
posure glass, start with the first
page to be copied.
When using Duplex,
copy is made Top to
Bottom even though
[Top to Top] is selected.
You placed the originals in the
wrong orientation.
Place the original in the correct
orientation. See “Original Orien-
tation”, Copy/Document Server
Reference.
Message Cause Solution
Memory is full.
nn originals
have been
scanned.Press
[Print] to copy
scanned origi-
nals. Do not re-
move remaining
originals.
“n” in the message rep-
resents a changeable
number.
The scanned originals exceeds
the number of pages that can be
stored in memory.
Press [Cancel] to copy scanned
originals and cancel the scanning
data. Press [Clear Memory] to can-
cel the scanning data and not
copy.
Press [Resume]
to scan and copy
remaining origi-
nals.
The machine checked if the re-
maining originals should be cop-
ied, after the scanned originals
was printed.
To continue copying, remove all
copies, and then press [Resume
Printing]. To stop copying, press
[Cancel].
To Next Page
Loading...
