Program / Change / Delete Scan Size
This section describes how to program, change, and delete a Scan Size.
• When programming or changing a scan size, it is recommended that you make a record of the new
size.
When you select a scan size to scan a custom size original, two custom sizes are available (Program Size
1 and Program Size 2). Use these functions to program a custom size in advance. The procedure is the
same for programming and changing.
You can program up to two sizes.
Specify a horizontal length from 128 to 1200 mm, or from 5.5 to 47 inches.
1. Press [Facsimile Features].
2. Press [Scan Settings].
3. Press [Program / Change / Delete Scan Size].
4. Select [Program Size 1] or [Program Size 2].
5. Enter a horizontal size using the number keys.
Each time you press [mm] or [inch], the units switch between "mm" and "inch".
If you enter a length and press [mm] or [inch], the length is converted automatically according to the
unit (fractions are rounded off). For example, when you enter [2], [2], and [0] in millimeters and
4. Facsimile Features
148
To Next Page
Loading...
Need help?
General
