When 1000BASE-T is operating, both LED are lit.
• If the optional Gigabit Ethernet board is installed, only the Ethernet interface and USB interface
on the Gigabit Ethernet board can be used.
• For details about how to turn on the main power switch, see "Turning On the Power", About This
Machine.
• For details about installing the printer driver, see "Preparing the Machine", Printer Reference.
Connecting to the USB Interface
This section describes how to connect the USB2.0 interface cable to the USB2.0 port.
• Properly shielded and grounded cables and connectors must be used for connections to a host
computer (and/or peripheral) in order to meet emission limits.
1. Connect the USB2.0 interface cable to the USB2.0 port.
2. Connect the other end to the USB2.0 port on the host computer.
• This machine does not come with a USB interface cable. Make sure you purchase the appropriate
cable for the machine and your computer.
• The USB2.0 interface board is supported by Windows Me / 2000 / XP / Vista, Windows
Server 2003, Mac OS X 10.3.3 or higher.
• For Windows Me:
Make sure to install "USB Printing Support". When used with Windows Me, only a speed
equal to that of USB1.1 is possible.
• For Mac OS:
Connecting to the Interfaces
19
To Next Page
Loading...
Need help?
General
