Menu User Tool Setting Requirements
File Transfer Reception Protocol As required
File Transfer POP3 / IMAP4 Settings As required
File Transfer Administrator's E-mail Address As required
File Transfer E-mail Communication Port As required
File Transfer
Program / Change /
Delete E-mail Message
As required
File Transfer Scanner Resend Interval Time As required
File Transfer Number of Scanner Resends As required
• For the Effective Protocol setting, check that the protocol you want to use is set to [Active].
• [LAN Type] is displayed when the wireless LAN interface board is installed. If both Ethernet and
wireless LAN are connected, the selected interface takes precedence.
• When POP before SMTP is set to [On], also make settings for Reception Protocol and POP3 / IMAP4
Settings.
• When setting POP before SMTP to [On], check POP3 port number in E-mail Communication Port.
• p.69 "Interface Settings"
• p.77 "File Transfer"
Wireless LAN
This section lists the settings required for sending e-mail with a wireless LAN connection.
For details about how to specify the settings, see "Interface Settings" and "File Transfer".
Menu User Tool Setting Requirements
Interface Settings/Network Machine IPv4 Address Necessary
Interface Settings/Network IPv4 Gateway Address Necessary
Interface Settings/Network DNS Configuration As required
Interface Settings/Network DDNS Configuration As required
Network Settings Required to Use E-mail Function
31
To Next Page
Loading...
Need help?
General
