Selection Signal Status
Sets the level for the select signal of the parallel interface.
The default setting is High.
Input Prime
Sets whether to validate or invalidate the input prime signal upon reception.
Normally, you do not need to change this setting.
The default setting is Inactive.
Bidirectional Communication
Sets the printer's response mode to a status acquisition request when using a parallel interface. If you
experience problems using another manufacturer's machine, set this to "Off".
The default setting is On.
When set to [Off], the bidirectional communication function will be disabled, and the printer driver
will not be installed under Windows Auto Detect function.
Signal Control
Specifies how error during printing or sending facsimile from the computer is to be dealt with.
Normally, you do not need to change this setting.
The default setting is Job Acceptance Priority.
Wireless LAN
This section describes the user tools in the Wireless LAN menu under Interface Settings.
[Wireless LAN] is displayed when this machine is installed with the wireless LAN interface board.
Be sure to make all settings simultaneously.
Communication Mode
Specifies the communication mode of the wireless LAN.
The default setting is 802.11 Ad-hoc Mode.
SSID Setting
Specifies SSID to distinguish the access point in infrastructure mode or 802.11 ad hoc mode.
The characters that can be used are ASCII 0x20-0x7e (32 bytes).
If blank is specified in 802.11 ad hoc mode, "ASSID" appears.
Ad-hoc Channel
Specify the channel to use when [802.11 Ad-hoc Mode] has been selected. Set the channel that
matches the type of wireless LAN being used.
The following channels are available:
Interface Settings
73
To Next Page
Loading...
Need help?
General
