Sending a Fax
• It is recommended that you call the receiver and confirm that they received the fax after sending
important documents.
A fax number can contain 0 to 9, pause, " ", " ", and space.
If necessary, insert a pause in the fax number. The machine pauses briefly before it dials the digits
following the pause. You can specify the length of the pause time in the [Pause Time] setting under fax
transmission settings.
To use tone services on a pulse-dialing line, insert " " in the fax number. " " switches the dialing mode
from pulse to tone temporarily.
If the machine is connected to a telephone network through a PBX, be sure to enter the outside line
access number specified in [PBX Access Number] before the fax number.
• No separator characters or spaces can be entered before the fax number.
Selecting Transmission Mode
There are two transmission modes: Memory Transmission and Immediate Transmission.
Memory Transmission
In this mode, the machine scans several originals into memory and sends them all at once. This is
convenient when you are in a hurry and want to take the document away from the machine. In this
mode, you can send a fax to multiple destinations.
In Memory Transmission mode, a single job can contain up to 10 pages, and the maximum of 5
jobs can be stored in the machine.
Immediate Transmission
In this mode, the machine scans the original and faxes it simultaneously, without storing it in
memory. This is convenient when you want to send an original quickly. In this mode, you can only
specify one destination.
Sending a Fax
59
To Next Page
Loading...
Need help?
General
