• You can specify which paper tray is selected first in [Paper Tray Priority] under [Tray Paper Settings]
menu when the trays are automatically selected while you are printing. For details about [Tray
Paper Settings], see page 82 "Tray Paper Settings Menu".
• If a paper jam occurs, printing stops after the current page has been printed out. After the jammed
paper is removed, printing restarts from the jammed page automatically. For details about how to
remove the jammed paper, see page 147 "Removing Paper Jams".
• After printing on envelopes, make sure to pull up the levers for printing on envelopes back to their
original positions. Leaving the levers lowered can cause print quality problems when printing on
paper other than envelopes. For details about the levers for printing on envelopes, see page 26
"Loading Paper".
If a Paper Mismatch Occurs
The machine reports an error if:
• The paper size does not match the print job's settings when [Size Mismatch Detection] under [Tray
Paper Settings] is enabled.
• The paper type does not match the print job's settings when [Input Tray:] is set to [Auto Tray Select].
There are two ways to resolve these errors:
Continue printing using mismatched paper
Ignore the error and print using mismatched paper.
Cancel the print job
Cancel printing.
• For details about [Size Mismatch Detection], see page 82 "Tray Paper Settings Menu".
• If [Auto Continue] under [System Settings] is enabled, the machine ignores the paper type and size
settings and prints on whatever paper is loaded. Printing stops temporarily when the error is
detected, and restarts automatically after about ten seconds using the settings made on the control
panel. For details about [Auto Continue], see page 79 "System Settings Menu".
Continuing printing using mismatched paper
If the paper is too small for the print job, the printed image will be cropped.
Basic Operation of Printing
61
To Next Page
Loading...
Need help?
General