When loading paper of a size that is not automatically detected, specify the paper size.
page 208 "Specifying the Paper Size That Is Not Automatically Detected"
page 209 "Specifying a Custom Size Paper Using the Control Panel"
• If you select Thick Paper 2 to 4, [Coated Paper: High Gloss], [Coated Paper: Glossy], [Coated
Paper: Matte], or [Label Paper] in [Tray/Paper Settings], air is blown out automatically to fan the
paper loaded in the wide LCT. Fan this paper before loading it.
• page 176 "Fanning the Paper"
• You can load envelopes in the wide LCT. When loading envelopes, place them in the correct
orientation.
• page 230 "Envelope Orientation and Recommended Status"
Loading Tab Stock into the Wide LCT
When loading tab stock, attach the tab sheet fence.
1. Open the front cover of the wide LCT, and then take out the tab sheet fence.
2. Close the front cover.
Loading Paper into the Paper Tray
199
To Next Page
Loading...
Need help?
General
