• Carbonless paper of Paper Weight 2 or less
1. Check that paper in the paper tray is not being used, and then pull the tray carefully out
until it stops.
2. Take out the small tab end fence from the pocket on the right-hand side of the paper
source tray.
3. Set the side fences to the size of the paper to be loaded, and then load paper into the
tray.
4. Attach the small tab end fence, and then align the end fence gently against the paper you
loaded while pressing the release button of the end fence.
5. Push the paper tray fully in until it clicks.
• Replace the small tab end fence after use.
Loading Paper into the Multi Bypass Tray (Tray A)
Use the multi bypass tray (Tray A) to use transparencies, translucent paper, and paper that cannot be
loaded in the paper trays.
Loading Paper
101
To Next Page
Loading...
Need help?
General
