• Contact your sales representative before moving the machine out of the building or to another
location in the building. A moving service can be provided for a fee.
Optimum Environmental Conditions After Moving the Machine
Optimum environmental conditions
• Be sure to locate the machine as close as possible to a wall outlet. This will allow easy
disconnection of the power cord in the event of an emergency.
• Keep the machine away from humidity and dust. Otherwise a fire or an electric shock might
occur.
• Do not place the machine on an unstable or tilted surface. If it topples over, an injury might
occur.
• After you move the machine, use the caster fixture to fix it in place. Otherwise the machine might
move or come down to cause an injury.
• Make sure the room where you are using the machine is well ventilated and spacious. Good
ventilation is especially important when the machine is used heavily.
• Keep the machine away from salt-bearing air and corrosive gases. Also, do not install the machine
in places where chemical reactions are likely (laboratories, etc.), as doing so will cause the
machine to malfunction.
Avoid the following environments when locating the machine. If the machine is placed somewhere
where the conditions are different from those recommended, a failure may occur.
• Low temperature and humidity or high temperature and humidity
The following is the recommended temperature and humidity range:
• Temperature: 10–32°C (50–89.6°F) (humidity to be 54% at 32°C, 89.6°F)
• Humidity: 15–80% (temperature to be 27°C, 80.6°F at 80%)
• Places that are exposed to direct sunlight or other sources of strong light (more than 1,500 lux)
• Places that are directly exposed to cool air from an air conditioner or heated air from a heater
(Sudden temperature changes can cause condensation to form inside the machine)
General Requirements
275
To Next Page
Loading...
Need help?
General
