Chapter 2 Command System RIGOL
MSO1000Z/DS1000Z Programming Guide 2-111
:MASK:CREate
Create the pass/fail test mask using the current horizontal adjustment parameter and
vertical adjustment parameter.
This command is valid only when the pass/fail test is enabled (:MASK:ENABle) and is not
in the run state (:MASK:OPERate).
:MASK:PASSed?
Query the number of passed frames in the pass/fail test.
The query returns an integer.
:MASK:FAILed?
Query the number of failed frames in the pass/fail test.
The query returns an integer.
:MASK:TOTal?
Query the total number of frames in the pass/fail test.
The query returns an integer.
:MASK:RESet
Reset the numbers of passed frames and failed frames as well as the total number of
frames in the pass/fail test to 0.
:MASK:PASSed?
:MASK:FAILed?
:MASK:TOTal?
To Next Page
Loading...
Need help?
General
