Chapter 2 FactoryTalk Batch Server introduction
26
• Performing Client Communications: Transfers data between the
process-connected devices (PCDs), operator displays, Human Machine
Interfaces (HMIs), databases, and various other software packages.
See the FactoryTalk Batch Equipment Editor User Guide and the FactoryTalk Batch
Administrator Guide for more detailed information about the FactoryTalk Batch
Server.
The installation process placed the SampleDemo1 and SampleDemo2 folders in
the BATCHCTL share on your hard drive. Within each of these SampleDemo
folders are four subfolders that contain the files for the area model. To run the
sample demonstrations, add a FactoryTalk Security user, configure the
FactoryTalk Batch Server to locate the area model, and then verify the recipes
in the area model.
For the sample demonstrations file, create FactoryTalk user accounts for an
operator and an engineer. Create these user accounts in the FactoryTalk
Directory.
To add sample FactoryTalk Security users:
1. Select Start > Rockwell Software > FactoryTalk Administration
Console. The Select FactoryTalk Directory dialog box opens.
Administrator privileges are required to perform this procedure.
2. Select Network to add this user account to the FactoryTalk Network
Directory, and select OK.
3. If not already logged on to the FactoryTalk Network Directory, the Log
On to FactoryTalk dialog box opens. In User name, type the user name
Sample demonstration
setup
Add sample FactoryTalk
Security users
To Next Page
Loading...
Need help?
General
