Chapter 4 FactoryTalk Batch Recipe Editor introduction
62
After a recipe is created or edited, it needs to be verified to make sure it was
configured properly and that it will run against a particular set of equipment
(the area model).
To verify the recipe:
1. Select the Verify button. The Verification Process Results dialog box
opens. The result should be: CLS_FRENCHVANILLA >> Verification
of recipes has completed.
2. Select Close.
Use the following instructions to remove a sequential step.
To remove a sequential step from the sample operation:
1. While still in the CLS_SWEETCREAM_OP:1 operation, select the
XFR_OUT:1 step.
2. Select the Remove Step button. The XFR_OUT:1 step is removed,
including its links and the following transition. The SFC automatically
rearranges to adjust for the removed step.
Use the following to remove a parallel step from the sample operation.
To remove a parallel step from the sample operation:
1. While still in the CLS_SWEETCREAM_OP:1 operation, select the
ADD_EGG:2 parallel step.
2. Select the Remove Step tool. The ADD_EGG:2 parallel step is removed,
including its links, and the following transition is re-configured. The
SFC automatically rearranges to adjust for the removed step.
Tip: Because transitions that follow parallel structures can be complex, the transition may
not reconfigure automatically. If the transition following the removed parallel step requires
reconfiguration, you must configure the transition manually.
Remove a sequential step
from the sample operation
Remove a parallel step from
the sample operation
To Next Page
Loading...
Need help?
General
