Chapter 3 FactoryTalk Batch Equipment Editor introduction
49
Both the WP_MIXER1 and WP_MIXER2 units require the ADD_WATER
phase. Rather than create two identical phases, you can share the phase
between the units.
To share equipment:
1. Select Go Up to return to the Unit level.
2. Double-click the WP_MIXER2 icon.
3. Select Share Unit. The Share Phase Between Units dialog box opens.
4. Expand WP_MIXER1, and then select WP_ADD_WATER_M1.
5. Select OK.
Use the following instructions to exit the FactoryTalk Batch Equipment
Editor.
To exit the FactoryTalk Batch Equipment Editor:
1. From the File menu, select Exit.
2. Select No to discard any changes you made to the .cfg file. This does
not discard any previously saved changes.
In this section, you:
• Opened the FactoryTalk Batch Equipment Editor.
• Examined the FactoryTalk Batch Equipment Editor window.
• Opened an area model.
• Created a phase class.
• Created a signature template.
• Enabled a command verification policy.
• Examined phase tags.
• Created a phase.
(See the FactoryTalk Batch Equipment Editor User Guide for more information
about the FactoryTalk Batch Equipment Editor.)
Exit the FactoryTalk Batch
Equipment Editor
FactoryTalk Batch
Equipment Editor summary
To Next Page
Loading...
Need help?
General
